www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
24
|
GB
12. Troubleshooting
Fault Possible cause Remedy
The compressor does
not start.
-
et-outlet.
Make sure that the extension cable is not too long. Use
an extension cable with large enough wires.
Outside temperature is too low.
Never operate with an outside temperature of below
+5° C.
Motor is overheated.
cause of the overheating.
The compressor starts
but there is no pres-
sure.
The non-return valve (17) leaks. Have a service center replace the non-return valve (17).
The seals are damaged.
The drain plug for condensation water
(10) leaks.
The compressor
starts, pressure is
shown on the pressure
gauge, but the tools
do not start.
The hose connections have a leak.
Check the compressed air hose and tools and replace
A quick-lock coupling has a leak.
-
sure regulator (5).
Increase the set pressure with the pressure regulator.
To Next Page
Loading...
