www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
23
Then blow out these parts with compressed air (ap-
prox. 3 bar) and reinstall in reverse order.
10.7 Storage
m Important!
Pull out the mains plug and ventilate the equip-
ment and all connected pneumatic tools. Switch
o the compressor and make sure that it is se-
cured in such a way that it cannot be started up
again by any unauthorized person.
m Important!
Store the compressor only in a dry location
which is not accessible to unauthorized per-
sons. Always store upright, never tilted! Oil may
leak out!
10.7.1 Releasing excess pressure
compressor and using the compressed air which
is still left in the pressure vessel, e.g. with a com-
pressed air tool running in idle mode or with a blow-
out pistol.
10.8 Service information
Please note that the following parts of this product
-
lowing parts are therefore also required for use as
11. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
-
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Old devices must not be disposed of with house-
hold waste!
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
-
-
trical and electronic equipment.
negative consequences for the environment and hu-
that are often contained in electrical and electronic
-
ral resources. You can obtain information on collec-
-
To Next Page
Loading...
Need help?
General
