Schindler 3100/3300/6300 J 43402603 / 01 189/269
Copyright © 2017 INVENTIO AG
STM Adherence
Stopping Accuracy
Emergency Stop
No Step
1
When the car door is open, switch the recall control to ON.
2 Attach a piece of paper to the door jamb just above the door sill.
The paper has to be visible from the floor when the car door is closed.
3 Move the car upwards with the recall control and, when the counterweight
comes to rest on the buffer(s), keep going (do not release the UP button) until
the STM starts slipping on the traction shaft.
4 Check the moving distance (excess travel) of the car by means of the paper at
the door jamb. The moving distance (excess travel) must be ≤
HGP + HPH +
10 mm
according to the layout drawing.
No Step
1
Call the empty car to the top floor.
2 Check the stopping accuracy.
If the stopping accuracy is below ± 10 mm, no measures have to be taken.
If not, the STM must be checked for dirt and must be cleaned.
3 Repeat the stopping accuracy test.
No Step
1
Move the empty car upward in inspection mode and stop before you reach the
top floor. The STM should not slip.
To Next Page
Loading...