SCHOTT ColdVision - Cleaning; Certifications; Assembly Location (Plant 3540)

To Next Page

To Previous Page

Safety Information

D20980.022 Rev C CV-LS User Manual Page 11

Cleaning

Both the housing and the front and back plates have a durable finish which should retain its original

luster for many years. Cleaning the exposed areas with a commercial glass cleaner will help to maintain

the finish.

Before beginning, remove the cord from the light source. Wipe the exposed areas of the housing and

front and back plates with either a soft cloth or a paper towel, moistened with a commercial glass

cleaner.

CAUTION

Do not use detergents, excess water, treated cloths, harsh cleaning or flammable agents or sprays. If

fluid spills into the interior, let the unit dry thoroughly before using. Periodically, any visible dust

accumulation should be removed using a vacuum or commercially available can of compressed air.

Certifications

The ColdVision Light Source conforms to the provisions of the following European directives:

 2006/95/EC (Low Voltage Directive)

 2004/108/EC (EMC Directive)

 2011/65/EU (RoHS)

The illumination systems observance of the basic requirements set forth in the directives mentioned

above is verified by technical documentation and in full compliance with the standards listed below:

Related product manuals