CV-LS Dashboard
D20980.022 Rev C CV-LS User Manual Page 75
UART
The UART settings allow the user to change the communications protocol of the Legacy UART pins in the
Multiport. The default settings are the most common UART port and should only be changed if the user
has purposely changed the settings in their command terminal.
Figure 22: UART (Left: Dashboard, Right: Web Interface)
This is the communications speed. The higher the number, the faster the unit
will be able to receive and transmit text. However, not all computers / UART
adaptors can run at the highest speed. If you cannot connect at a higher
speed, work up to the highest speed your computer can use.
These settings rarely need to be changed. They affect the protocol used to
transmit characters.
To Next Page
Loading...
