Operating, Mounting and Maintenance Instructions
en
TDO--Ge
6/
8
Safety and Enviromental Protection Regulation “SV 1” 3 348/98 1099236
SCHOTTEL products which, due to their weight, can-
not be lifted without the use of auxiliary equipment,
must be fixed to a raising harness only at the lifting
points provided. If necessary, ask about possible lift-
ing points at SCHOTTEL--Werft.
Components to be removed which, due to their
weight, cannot be lifted without the use of auxiliary
equipment, must be supported accordingly and fixed
to the raising harness at the lifting points provided for
this purpose. If necessary, ask about possible lifting
points at SCHOTTEL--Werft. The raising harness
and hoist must be selected in accordance to the load
to be lifted.
Do not walk or stand under raised loads.
Unauthorized conversions and alterations to
SCHOTTEL products are prohibited.
Spare parts and assessories not supplied by the
SCHOTTEL--Werft are also not checked or accepted
by us. The installation and/or use of such parts may,
therefore,have a possible negative influence on the
design features of our products, so that the active
and/or passive safety of these is reduced.
SCHOTTEL--Werft is excluded from any liability
whatsoever for damages resulting from the use of
such parts.
When removing propellers and flanges which have to
be pressed on and off hydraulically, these must be
secured against falling down with the pressure plate
(2/2) specified.
Do not walk or stand in f ront of the pressure
plate!
Figure 2
2
To Next Page
Loading...
