SCHOTTEL SV 1 - Removing the Underwater Gears of SRP

en
TDO--Ge
7/
8
Safety and Enviromental Protection Regulation “SV 1” 3 348/98 1099236
5 Removing the underwater gears of SRP
When removing the underwater gear--box, the power
transmission shaft (3/4) may remain in the surface
gear--box and drop down later uncontrolled ! There-
fore, lower underwater gearbox a little and turn the
surface gear--box to and fro at the power inlet (3/3)
until the shaft sinks down to the underwater gear--
box. Remove underwater gear--box together with the
power transmission shaft.
Figure 3
3
4