SCOTT Protege SG - Monitor Overview

8 CHAPTER 2: INTRODUCTION
087-0065 REV B SCOTT SAFETY
Monitor Overview Protégé Single Gas is a portable gas detector designed to monitor different hazardous
gas levels. With one-button activation, a direct reading segment LCD, and bright
LEDs, Protégé Single Gas is simple to use. Due to its small size and light weight (5.3
oz.), the monitor is comfortable to hold and handle. All filters, lithium batteries,
alligator clips and sensors are field replaceable.
The monitor contains a data log for greater than 5000 events and records
STEL/TWA/PEAK exposures, calibrations and gas values. An IR connection allows
quick parameter configuration, monitor calibration and event log retrieval via the
Portable Gas Detection (PGD) Application Software.
The below list shows all the available interchangeable smart sensor options for the
Protégé Single Gas monitor.
LEL CH
4
(Methane)
CO (Carbon Monoxide)
CO (Carbon Monoxide) - H
2
Resistant
H
2
S (Hydrogen Sulfide)
H
2
S (Hydrogen Sulfide) - High Resolution
O
2
(Oxygen)
O
3
(Ozone)
HCN (Hydrogen Cyanide)
NO (Nitric Oxide)
NO
2
(Nitrogen dioxide)
PH
3
(Phosphine)
SO
2
(Sulfur Dioxide)
NH
3
(Ammonia)
Cl
2
(Chlorine)
ClO
2
(Chlorine dioxide)
Caution
: Use caution when changing alarm set points. Confirm these levels with
your company safety officer.
Warning
: Do not use IR communications when an explosive atmosphere may be
present.
If you have any questions about the device or its operation contact Scott Safety. See
“Technical Service” on page 52”.