Protégé Portable Gas Monitor
Instruction Manual
28 of 61
P/N 087-0038 Rev. J 02/10
3) Date is displayed.
4) Time is displayed.
5) Low Alarm settings displayed.
6) High alarm settings displayed.
7) STEL alarm setting displayed.
8) TWA alarm setting is displayed.
9) Cal Due – indicates when next calibration is due in days.
WARNING
OPERATING A PROTÉGÉ MONITOR THAT HAS EXCEEDED ITS CALIBRATION DATE CAN CAUSE FALSE READINGS OF
DETECTED GASES. DO NOT TRUST INVALID READINGS OBTAINED WHILE UNIT IS OUT OF CALIBRATION.
OPERATING A PROTÉGÉ THAT IS OUT OF CALIBRATION MAY NOT ACCURATELY INDICATE ENVORONMENTAL
CONDITIONS WHICH CAN LEAD TO DEATH OR INJURY.
WARNING
IF CAL EXPIRED IS DISPLAYED UPON POWER ON START UP SEQUENCE INDICATING THE UNIT DOES NOT HAVE
VALID CURRENT CALIBRATION, PRESS THE RIGHT OPERATIONAL BUTTON TO OVERRIDE AND IMMEDIATELY
CALIBRATE THE MONITOR. A PROTÉGÉ THAT HAS NOT BEEN PROPERLY CALIBRATED CAN LEAD TO DEATH OR
INJURY.
WARNING
NEVER OPERATE A PROTÉGÉ MONITOR IN GAS MONITORING MODE WITH THE CALIBRATION ADAPTER
ATTACHED. THIS CAN CAUSE FALSE READINGS OF DETECTED GASES. FAILURE TO DO SO CAN LEAD TO DEATH OR
INJURY.
After this sequence is complete, the Protégé will resume typical monitoring.
4.1.2. Powering Off
Press and hold both operational buttons simultaneously until the countdown timer has completed
and the LCD is blank. If the buttons are held for 5 seconds after the LCD goes blank, the Protégé
will attempt to power back on.
NOTE
T
HE TIMING PARAMETER WILL VARY AS SET USING THE SCOTT GAS MONITOR SOFTWARE. REFER TO
PARAGRAPH 4.6.3 FOR INFORMATION ON HOW TO ADJUST THIS PARAMETER.
To Next Page
Loading...
