Dive in GAUGE mode
m WARNING!
This manual does NOT replace adequate training!
The next diagram shows the information displayed when diving in gauge mode:
m WARNING!
Adequate training is required to use JACK in GAUGE mode.
In Gauge mode, JACK shows:
Current depth (at upper left): Expressed in meters or feet.
Run Time (at upper right): Time elapsed since the beginning of the dive.
Resettable timer (at center): Timer in mm:ss that can be reset by pressing the
C button. Press the D button to move from Timer to AVG Depth (average depth).
AVG Depth (at center): Average depth, resettable by pressing the C button.
Temperature (at lower left): Current temperature.
Ascent rate (at center bottom): Current ascent rate in m/min (or ft/min)
Maximum depth (at lower right): Maximum dive depth.
JACK also calculates tissue saturation and desaturation in GAUGE mode using
an imaginary MIX with a high content of inert gases (10/60, recorded in the
LogBook). If after a dive in GAUGE mode you want to take a dive in OC using
the decompression calculations, JACK will consider the new dive to be the next
repetitive dive of the day.
PLEASE NOTE
Even if JACK performs the decompression calculations in the background,
they will not be displayed on screen, and they also have no effect in GAUGE
mode.
Move to
AVG Depth
Reset
Timer
Move to
Timer
Reset AVG
Depth
Compass
Compass
To Next Page
Loading...
