BGX501-742-R01, APEX100 User Manual
2. Select Get configuration.
3. Select either SML or DLMS mode.
4. M-Cubed will now attempt to communicate with the meter. If the meter is not connected or is switched off
then a warning screen will be displayed.
5. The current configuration from the meter will now be downloaded. A warning screen will be displayed if the
meter type is not supported.
6. Click Save to keep a copy of the tariff file for further use.
3.1.3 Modifying a Current Tariff
1. Click on Configuration.
2. Select Modify Configuration.
3. Select the required tariff file. SML or DLMS mode will be automatically selected.
4. Modify the tariff configuration accordingly.
5. Save this tariff file for further use.
3.1.4 Viewing a Current Tariff
1. Select the meter for which you wish to view data.
2. If the meter data is corrupted then a warning window will be displayed indicating that this session‟s data is
corrupted.
3.1.5 Hand Held Unit (HHU) Operations
HHUs and USB pen drives can be setup and used to do the following operations:Create ScheduleHHU
PrepareRead HHUClear HHU
1. Select Create Schedule, HHU Prepare, Read HHU and Clear HHU operation.
2. Select either ANALOGIC MRI or USB Pen Drive to perform specific operation with HHU.
3. USB pen drive transactions will not be allowed if the selected schedule file already contains transaction
information. A warning screen will be displayed stating that the transactions will not be allowed.
4. The schedule file also contains the following OBIS codes:
Meter Serial No
Date and Time
CLEM Name
Read Capture periods (SIP & DIP)
Meter Type (subject to availability).
5. A warning screen will be displayed if the USB Pen Drive or HHU Device is not properly connected with the
PC.
6. If the Clear HHU operation is selected then the connected pen drive will be fully formatted. A warning screen
will be displayed if an error is detected.
To Next Page
Loading...
