The IP Camera
requires that TCP Port 80 and UDP 9001 (default settings) be opened
to the Internet. TCP Port 80 is used for accessing the camera’s homepage and UDP
Port
9001 is used for authentication and video streaming.
If your Internet Service
Provider (ISP) blocks
port 80/9001, you’ll need to
reconfigure your camera and router to other ports such as 81/9002, 82/9003, etc. To
change the port settings on
the camera, you’ll need to use Netility.
Follow the steps below to configure your router, depending on the router manufacturer
and model. If your particular router manufacturer or model is not listed below, please
contact your router manufacturer for further assistance in
configuring your router.
The Following Router manufacturers and models are included in this document:
Brand
Model
Description
3Com
3C857-US
OfficeConnect
Cable/DSL
Gateway
3CRWE52196
OfficeConnect
Wireless
Cable/DSL
Gateway
Belkin
F5D6230-3
Wireless Cable/DSL Gateway Router
F5D7230-4– 54g
Wireless DSL/Cable gateway Router
D-Link
DI-604/DI–614+/DI-624
-
DI-704/704P
-
DI714
-
DI-714P+
-
Dell
TrueMobile
2300
Wireless
-
Broadband Router
Linksys
BEFSR41
EtherFast Cable/DSL Router
BEFSX41
Instant Broadband EtherFast Cable/DSL
Firewall
Router
with
4-Port
Switch/VPN EndPoint
BEFW11S4
Wireless Access Point
Router with
4-Port
Switch – Version 2
Microsoft
MN-100
Wired
Base
Station
MN-500
Wireless
Base
Station
NETGEAR
RP614
Web Safe Router
MR814
Wireless
Router
MR314
Cable/DSL
Wireless
Router
FVS318
ProSafe
VPN
Firewall
Proxim
ORiNOCO
BG-2000
-
Broadband Gateway
Siemens
SpeedStream 2602
2-Port DSL/Cable Router
SpeedStream 2623
Wireless DSL/Cable Router
IP Camera Manual 48
To Next Page
Loading...
