EasyManua.ls Logo

SED 024.16.720 - 4 BASIC Safety Instructions

SED 024.16.720
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.sed-owcontrol.com
11
Basic Safety Instructions
Type 024.16.720
4. BASIC SAFETY INSTRUCTIONS
These safety instructions do not make allowance for any
•contingencies and events which may arise during the installation, operation and maintenance of the
devices.
•localsafetyregulations–theoperatorisresponsibleforobservingtheseregulations,alsowithreferenceto
the installation personnel.
DANGER!
Danger – high pressure!
Before dismounting pneumatic lines and valves, turn off the pressure and vent the lines.•
Risk of electric shock!
Before reaching into the device or the equipment,• switch off the power supply and secure to prevent
reactivation!
Observe applicable accident prevention and safety regulations for electrical equipment!•
General hazardous situations.
To prevent injury, ensure:
that the system cannot be activated unintentionally.•
Installation and repair work may be carried out by authorized technicians only and with the appropriate •
tools.
After an interruption in the power supply or pneumatic supply, ensure that the process is restarted in a •
denedorcontrolledmanner.
The device may be operated only when in perfect condition and in consideration of the operating •
instructions.
The general rules of technology apply to application planning and operation of the device.•
NOTE!
Electrostatic sensitive components / modules!
The device contains electronic components, which react sensitively to electrostatic discharge (ESD). •
Contact with electrostatically charged persons or objects is hazardous to these components. In the worst
case scenario, they will be destroyed immediately or will fail after start-up.
Observe the requirements in accordance with EN 100 015 - 1 and 5 - 2 to minimize or avoid the possibility •
of damage caused by sudden electrostatic discharge!
Also ensure that you do not touch electronic components when the power supply is on! •
The positioner Type 024.16.720 was developed with due consideration given to the accepted safety
rules and is state-of-the-art. Nevertheless, dangerous situations may occur.
Failure to observe this operating manual and its operating instructions as well as unauthorized tampering
with the device release us from any liability and also invalidate the warranty covering the devices and
accessories!

Table of Contents