SED 024.16.720 - Page 44

www.sed-owcontrol.com
44
Electrical Installation 24 V DC
Type 024.16.720
Outputsignalstothecontrolcenter(e.g.PLC;foranalogoutputoptiononly)
Terminal Conguration External circuit
2
3
Analogue position feedback +
Analogue position feedback GND
2
3 GND
+ (0/4 ... 20 mA)
not galvanically isolated
Table 18: Assignment of screw-type terminals - output signals to the control center - cable gland
Electrical power supply
Terminal Conguration External circuit
6
7
Power supply +
Power supply GND
6
7
24 V DC ± 10 %
max. residual ripple 10 %
Table 19: Assignment of screw-type terminals - power supply - cable gland
→ Close the body.
When the power supply is applied, the positioner is operating.
→ Make the required basic settings and actuate the automatic adjustment of the positioner, as described in
the chapter entitled “13. Start-Up”.