In the test mode, ascertain that the assembly has been made correctly and IC Board is satisfactory.
In the test mode, perform the following tests (refer to chapter 9):
9-3-3 INPUT TEST
This menu is used to test the system inputs such as triggers, pedals and buttons. To implement the test, press each
device that is listed and check the results on screen.
9-3-4 OUTPUT TEST
This menu is used to test the system outputs such as Lamps and LEDs.
9-3-6 CONTROLLER ADJUSTMENT
This test is required to calibrated both Gun Controllers. This procedure is always carried out at the factory before
dispatch. However, certain conditions can have an eect on calibration and it is recommended that re-calibration be
carried out at point of installation.
9-8 SPEAKER TEST
This menu is used to test the system audio devices are working,
9-9 COIN SETTINGS
As this system utilises a Credit Board PCB, it is important that the setting remain 1 COIN 1 PLAY. Deviation from
this setting when using the Credit Board PCB can result in unusual credit outputs.
6-5 CONFIRMATION OF ASSEMBLY
To Next Page
Loading...
Need help?
General
