7 PRECAUTIONS WHEN MOVING THE MACHINE
• When moving the cabinet, do not grip or push the Reector Plates. Doing so
could deform or damage the part.
• If moving through a door or place with a low ceiling such as an elevator, you
should take apart the billboard and reector plates.
• Always disconnect the power cable before moving the product. If it is moved
with the power cable connected, the cable could be damaged, causing re
or electric shock.
• To move the unit over the floor, pull in the adjusters and have the casters
contact the floor. While moving the unit, be careful that the casters do not
roll over the power cord or the ground wire. If cord or wire is damaged, there
could be electrical shocks and/or short circuits.
• When crossing a sloped or stepped area, always have the machine travel
lengthways. Travelling with the machine in a sideways position could result in
the machine falling over onto its side. Always use a minimum of two people
working together plus lifting apparatus to accommodate slopped areas or
stairs.
• To lift the cabinet, raise it at the bottom at the designated lifting points. If you
hold it anywhere else, the weight of the cabinet could cause damage to parts
or attachments, resulting in injury.
• Do not push the cabinet from the side when moving. Pushing from the side may
result in the cabinet falling over.
To Next Page
Loading...
Need help?
General
