• Make sure that all the adjusters contact the oor. Otherwise the cabinet could
move, causing an accident.
• Provide a ventilation space at least 20cm wide behind the cabinet. There are
ventilation holes on the back of the cabinet. Do not block the ventilation holes.
Doing so could trap heat inside resulting in re. It could also result in equipment
damage or cause parts to become exhausted prematurely.
The product is equipped with 4 casters and 4 adjusters.
When installation position / site has been determined, have the adjusters come in direct contact with the floor.
Establish a gap of about 5 mm between the oor and the casters and adjust the unit so that it will remain level.
1. Move the product to the installation site.
2. Bring the adjusters into direct contact with the oor. Use a wrench to align the height of the
adjusters until the cabinet is perfectly level.
3. After setting, turn adjuster nuts upwards to tighten them and secure adjuster heights.
6-2 FIXATION TO SITE
Approx. 5 mm
ADJUSTER
Fasten the nuts in an
upward direction.
ADJUSTER
CASTER
Castors
Castors
Leg Levellers
Leg Levellers
To Next Page
Loading...
