There are microswitches for the trigger and shot selector and action button inside the control unit.
1
Refer to 14-2 “REMOVING THE CONTROLLER SUPPORT ” and 14-3 “REMOVING THE SCOPE,” take o
the controller support and scope body.
2
Place cover R face down on the work surface and remove the 15 screws to take o the cover L.
SCREW (15)
M3 x 12, w/at & spring washers
COVER L
3
Remove the microswitch from the R cover.
509-5080
MICROSWITCH FOR
ACTION BUTTON
MICROSWITCH FOR SHOT SELECTOR
509-5080
MICROSWITCH FOR
TRIGGER
509-5080
10-4 REMOVING THE MICROSWITCH
To Next Page
Loading...
