5
Remove the 8 screws and replace the solenoid.
N
OTE: When attaching it, use a thread sealant.
124-5113
SCREW (8)
M3 x 6, w/spring washer
SOLENOID
6
Refer to Step 1 to 5 and work in reverse order to reassemble the control unit. Refer to the gure and be
careful with the order in which the small parts are attached and the direction the side with the solenoid
cable faces. Attaching the parts the wrong way may result in malfunction of the unit or pinching of the
cable. Be careful not to tighten screws excessively.
7
Carry out an input test, controller adjustment and speaker test, and adjust the operation of each of the com-
ponents.
(
See chapter 9.
)
To Next Page
Loading...
