Segway NINEBOT ONE S1 - Battery Cover

Batteries
14
One S1
Battery Cover
Tools Required
• Phillips screwdriver
Removal
Make sure the One S1 is powered off and the
charger is not connected.
1. Remove the silicone plug (Figure 1).
2. Use a Phillips screwdriver to remove the two
screws (Figure 2).
3. Use your hand to grab the battery cover between
the now-empty screw holes. Pull the battery cover
off the One S1.
NOTE
It may take a great deal of force to remove the
battery cover.
Installation
1. Verify that the gasket is securely installed in the
groove (Figure 3).
2. Position the battery cover on the One S1. Line
up the tabs on the cover with the slots on the
housing (Figure 4).
3. Press the battery cover onto the housing. Press
until it snaps in place.
4. Use a Phillips screwdriver to install the two screws
removed earlier (Figure 2).
5. Reinstall the silicone plug (Figure 1).
Figure 1: Remove the silicone plug
Figure 2: Remove the two Phillips-head screws
Figure 3: Verify gasket is installed
Figure 4: Line up cover tabs with slots in the housing
Gasket