Service Manual 23
LED Strips
LED Strips
Tools Required
• Flathead screwdriver
Removal
Make sure the One S1 is powered off and the
charger is not connected.
1. Remove the following components:
a. Both battery covers (page14).
b. Both batteries (page15).
c. LED cover(s) (page22).
2. Gently pull the LED strip connector out from
behind the housing, and unplug the connector
(Figure 15).
3. The LED strip is held in place with double-sided
tape. Gently peel the LED strip off.
4. Use a athead screwdriver or similar tool to
scrape off any double-sided tape residue
(Figure 16).
Installation
1. Install in the reverse order of removal.
Scrape off residue
Unplug
Figure 15: Unplug the LED strip
Figure 16: Scrape off any residue
To Next Page
Loading...
