Segway NINEBOT ONE S1

To Next Page

To Previous Page

Frame

One S1

Charge Port

Tools Required

• 15 mm socket

• Locking pliers

• Flathead screwdriver

• CA glue

Removal

Make sure the One S1 is powered off and the

charger is not connected.

1. Access the charge port:

a. Disassemble the One S1 (page28).

b. Remove the control board (page38).

c. Remove the rear frame (page42).

2. Thread a 15 mm socket over the charge port

wires. Grip the socket with locking pliers. Remove

the nut on the back of the charge port connector.

NOTE

If you cannot remove the charge port, replace the

rear frame.

3. Open the charge port cover and pull the charge

port out of the rear frame. Carefully guide the

wires through the hole.

Installation

1. Insert the charge port through the hole in the

rear frame.

2. Thread the nut onto the back side of the charge

port. Do not tighten fully.

3. Apply a drop of CA glue underneath the nut.

4. Thread a 15 mm socket over the charge port

wires. Grip the socket with locking pliers, and

tighten rmly.

5. Continue to install in the reverse order of

removal.

Figure 66: Remove the nut

Figure 67: Charge port

Segway NINEBOT ONE S1 - Charge Port