Body
32
One S1
Body Assembly
Follow these steps to assemble together a frame,
wheel, and two side panels. Combined, these
components make up the body of a One S1.
Tools Required
• 3 mm hex wrench
• Phillips screwdriver
• 705 RTV Sealant
Mount Wheel onto Right Side Panel
1. Take note of which side of the wheel has the
wires extending from the hub (Figure 29). This is
the right side of the wheel.
NOTE
Side panels are interchangeable, however it is
best to keep them oriented as they were before
disassembly. The right side panel has the motor
harnesses running through it and has three wire
guides. The left side panel has only one wire
guide.
2. Mount the wheel onto the right side panel.
See Figure 30.
a. Thread the motor harness through the hole in
the side panel.
b. Using a 3 mm hex wrench, install the four
fasteners securing the side panel to the
wheel.
3. Install the large wire guide (MK2) over the motor
harness wires where they enter the side panel.
See Figure 31.
4. Use 705 RTV Sealant to secure the harness where
it exits the wire guide. Apply sealant all the way
around the wire.
Figure 29: Wheel orientation
Figure 30: Right side panel and wheel
Right SideLeft Side
Figure 31: Wire guide
Apply sealant here
Motor Harness
To Next Page
Loading...
