69
Post-Service Tests
Service Manual
Post-Service Tests
These are the standard tests to perform after servicing a One S1.
Physical Check
1. Check that the handle is secure.
2. Check the wheel for wear, tightness (make sure there is no side-to-
side play), and tire pressure.
3. Check that the foot pedals are secure.
4. Check to make sure no part is damaged or loose.
Startup Test
5. Use the ON/OFF button to power ON the One S1.
6. Verify that the unit turns on and the LED light strips on both sides
work.
7. Verify the ON/OFF button is lighted and slowly blinks, indicating
proper operation.
Charging Test
1. Turn OFF the One S1.
2. Plug in the charger and connect it to the One S1.
3. Verify that the charger LED is illuminated, indicating proper
charging (a Red LED indicates charging, a Green LED indicates the
battery is fully charged).
Operational Test
1. Turn ON and power OFF the One S1 twice.
2. Conrm adequate battery level (see the Ninebot One S1 by
Segway User Manual for information on checking battery charge
level).
3. Use the handle to lift the One S1 off the ground while powered on.
Verify that the unit beeps and the wheel does not spin.
NOTE
If the wheel continues to spin after being lifted, verify that this
feature has not been disabled in the app.
4. Turn the One S1 OFF.
To Next Page
Loading...
