Segway NINEBOT ONE S1 - Tire;Inner Tube

Service Manual 53
Wheel and Tire
Tire/Inner Tube
Tools Required
• Two tire irons
• Safety glasses
Removal
Make sure the One S1 is powered off and the
charger is not connected.
1. Remove both battery housings (page28).
2. Remove the valve stem cap and completely
deate the tire by pushing down on the valve
needle while squeezing the tire (Figure 77).
3. Release the bead on both sides of the tire.
4. Pry one end of a tire iron underneath the lip of
the tire bead, pulling the bead up above the rim.
5. Insert a second tire iron under the tire bead
about six inches away from the rst tire iron
and pry that portion of the tire over the rim
(Figure 78). Repeat until the entire bead of one
side of the tire is lifted over the rim.
6. Push the valve stem through the rim and into
the tire, then remove the inner tube from the tire
(Figure 79).
7. If replacing the tire, work the other bead over the
wheel to remove the tire completely.
Installation
1. Install in the reverse order of removal.
NOTE
Seat the tire bead on the wheel by hand before
installing the inner tube. Inate the inner tube
with just enough air to give it a circular shape,
then seat the other tire bead. Be careful not to
pinch or trap the inner tube between the tire and
wheel rim.
CAUTION!
To avoid pinching, keep hands and ngers away
from the bead during ination.
Figure 78: Pry up bead with tire irons six inches apart; repeat
Figure 79: Remove inner tube from tire
Figure 77: Completely deate the tire/inner tube
Valve stem