Frame
44
One S1
ON/OFF Button
Tools Required
• Flathead screwdriver
Removal
Make sure the One S1 is powered off and the
charger is not connected.
1. Disassemble the One S1 (page28).
2. Remove the control board (page38).
3. Remove the front frame (page42).
4. Using a athead screwdriver, press rst one tab
and then the other (Figure 62) to remove the
ON/OFF button from the front frame. Press the
tabs in toward the center.
5. Remove the spring (Figure 63).
Installation
1. Install in the reverse order of removal.
Figure 61: ON/OFF button installed
Figure 62: Press the tabs to remove
Figure 63: ON/OFF button and spring
Press in
Press in
ON/OFF Button
To Next Page
Loading...
