Service Manual 19
Pedals
Pedal Components
Each pedals is composed of:
• Base
• Cover
• Grip tape, small
• Grip tape, large
Holding the cover onto the base are:
• Threaded inserts (6 per pedal)
• M4x10 athead screws (6 per pedal)
Tools Required
• 2.5 mm hex wrench
Disassembly
Make sure the One S1 is powered off and the
charger is not connected.
NOTE
You can perform these steps with the pedal still
attached to the unit, however it is easier if you
remove the pedal rst (page18).
1. Peel both pieces of grip tape off the pedal and
discard (Figure 10).
2. Using a 2.5 mm hex wrench, remove the six
fasteners.
3. Separate the pedal cover from the pedal base
(Figure 11).
4. To remove threaded inserts (Figure 12): insert a
screw into the threaded insert, then tighten the
screw to press the threaded insert out.
Assembly
1. To install threaded inserts (Figure 13): orient the
threaded insert with the knurled edge up and
press it rmly into the hole.
2. Install in the reverse order of removal.
WARNING!
Always install new grip tape. Old/reused grip
tape could come loose while riding.
Figure 10: Grip tape removed
Knurled edge up
Figure 11: Pedal cover (left) and base (right)
Figure 12: Threaded insert, present (left) and absent (right)
Figure 13: Threaded insert
To Next Page
Loading...
