Frame
48
One S1
Buzzer
Tools Required
• Knife
• Hot melt glue
Removal
Make sure the One S1 is powered off and the
charger is not connected.
1. Disassemble the One S1 (page28).
2. Remove the control board (page38).
3. Use a knife to separate the glue from the frame.
4. Remove the buzzer.
Installation
1. Insert the buzzer into the hole.
2. Apply a generous glob of hot melt glue to hold
the buzzer in place.
3. Continue to install in the reverse order of
removal.
Figure 70: Buzzer
Figure 71: Glue holds buzzer in place
To Next Page
Loading...
