Segway NINEBOT ONE S1 - Hub Brackets

Wheel and Tire
52
One S1
Hub Brackets
Tools Required
• 13/16-inch socket
• Pass-through socket wrench
• Large athead screwdriver
Removal
Make sure the One S1 is powered off and the
charger is not connected.
1. Disassemble the One S1 (page28).
2. Lay the wheel horizontally between two tables, as
shown in Figure 74.
3. Remove the hub nut, as shown in Figure 74. Use
a 13/16-inch pass-through socket wrench and a
large athead screwdriver (or metal rod) to turn
the hub nut loose.
4. Use a athead screwdriver to pop loose the axle
clamps (Figure 75).
5. Lift the bracket and clamps off the wheel shaft
6. Remove the hub bushing (Figure 76).
Installation
1. Install in the reverse order of removal.
Figure 74: Removing the hub nut
Figure 75: Pop loose the axle clamps
Figure 76: Remove the hub bushing
Hub Bushing