9
Introduction
Service Manual
Introduction
Purpose
The purpose of this manual is to provide instructions for servicing the
Ninebot One S1 by Segway.
Audience
This manual is written for authorized service technicians.
General Service Procedures
Before performing any service on the One S1, you must rst determine
which components may be damaged or malfunctioning. In some cases
this requires a simple visual inspection — as in the case of a cracked or
damaged housing. In other cases diagnostic equipment must be used
to troubleshoot the problem — as in the case of a vehicle limiting the
maximum speed to lower than expected.
No matter what the problem is, the service procedure is the same:
1. Identify — identify the symptoms.
2. Diagnose — determine which components may be malfunctioning.
3. Replace — replace the malfunctioning component(s).
4. Verify — operate the vehicle to verify the problem has been solved.
It may be the case that there are multiple problems affecting a One S1.
Try to isolate the problems and solve them one at a time.
Related User Materials
This document is a service manual intended for use by trained
technicians to service and repair the One S1. It does not contain
general operating information. The following additional user materials
may be needed for reference during service:
• Ninebot One S1 by Segway User Manual
Please check www.segway.com for the latest user manual, and/or
contact Segway to conrm you have on hand the most recent service
publications.
Unit Orientation
When servicing the One S1, unit orientation is referenced as shown in
the illustration to the right
Charging Port
(rear)
ON/OFF Button (front)
Left Right
To Next Page
Loading...
