Service Manual 43
Frame
Handle
Tools Required
• Phillips screwdriver
Removal
Make sure the One S1 is powered off and the
charger is not connected.
1. Disassemble the One S1 (page28).
2. Remove the control board (page38).
3. Remove the front and rear frames (page42)
CAUTION!
The handle is under spring tension, be careful
when removing it.
4. Carefully remove the handle (Figure 58).
Installation
1. Inspect the handle to determine which end has
the magnet embedded in it (end closest to the
“n” in “ninebot”). Orient this end toward the ON/
OFF board (Figure 60).
CAUTION!
This magnet is used to activate Carry Mode when
the unit is lifted by the handle while powered
ON. Orienting it the other way could cause Carry
Mode not to activate when the user lifts the unit.
2. Install in the reverse order of removal.
Figure 58: Upper frame and handle assembly
Figure 59: Handle
Figure 60: Handle orientation
Handle
Upper Frame
ON/OFF Board
“ninebot one”
To Next Page
Loading...
