Segway NINEBOT ONE S1 - Resetting the Serial Number

Ninebot App
64
One S1
Resetting the Serial Number
Follow these steps to reset the Serial Number back to the original serial
number. This is necessary when installing a new Control Board (see
“Control Board,” page38).
1. Open the Ninebot App and connect to your One S1.
2. Go to the Settings Menu.
3. Select Other Settings.
4. Select Change Serial Number.
5. Read the Serial Number off the label on the underside of the right
foot pedal. Enter this number as the Target Serial Number.
6. Enter the Target Serial Number.
7. Take a screenshot showing the Target Serial Number and the
Additional Code and email it to technicalsupport@segway.com.
8. Segway Technical Support will reply with the appropriate Check
Code / Verication Code.
9. Input the Check Code / Verication Code.
10. Press the check mark to set the Serial Number.