LED Strips
22
One S1
LED Covers
Tools Required
• Phillips screwdriver
Removal
Make sure the One S1 is powered off and the
charger is not connected.
1. Remove the following components:
a. Both battery covers (page14).
b. Both batteries (page15).
2. Use a Phillips screwdriver to remove the six
screws (Figure 14).
3. Remove the LED cover.
Installation
1. Install in the reverse order of removal.
NOTE
Be careful not to pinch any wires when installing
the LED cover.
Figure 14: Remove the six screws
To Next Page
Loading...
