Segway NINEBOT ONE S1 - ON;OFF Board

Service Manual 45
Frame
ON/OFF Board
Tools Required
• Phillips screwdriver
Removal
Make sure the One S1 is powered off and the
charger is not connected.
1. Disassemble the One S1 (page28).
2. Remove the control board (page38).
3. Remove the front frame, rear frame, and handle
(page42).
4. Using a Phillips screwdriver, remove the three
screws holding the ON/OFF board onto the
upper frame (Figure 64).
5. Gently lift the ON/OFF board off the upper frame
while carefully guiding the wires through the hole
in the upper frame.
Installation
1. Install in the reverse order of removal.
Figure 64: Remove the three screws
Figure 65: ON/OFF board