Segway NINEBOT ONE S1 - Pedals

Pedals
18
One S1
Pedals
Tools Required
• 2.5 mm hex wrench
• 5 mm hex wrench
• Punch
Removal
Make sure the One S1 is powered off and the
charger is not connected.
1. Loosen the set screw in the bottom of the bracket
(Figure 8).
2. Remove the end fasteners from both ends of the
pedal (Figure 8).
NOTE
You may need to use signicant force to break
the tension when removing these fasteners.
3. Using a punch or similar tool, tap out the rod.
4. Retain the bushings and spacers for installation.
Installation
1. Install in the reverse order of removal.
NOTE
Be sure to install the bushings and spacers as
shown in Figure 9.
Figure 8: Remove the pedal fasteners
Figure 9: Retain the bushings and spacers
Rod
Bushings
Spacer Spacer
End Fastener End FastenerSet ScrewRod