Service Manual 49
Frame
Temperature Sensor
Tools Required
• Knife
• Thermally conductive epoxy
• Tape
Removal
Make sure the One S1 is powered off and the
charger is not connected.
1. Disassemble the One S1 (page28).
2. Remove and disassemble the Control Board
(page38).
3. Use a knife to scrape the glue off the heat sink
around the temperature sensitive resistor.
4. Gently but rmly pull the resistor out of the hole.
5. Scrape off any remaining residue on the heat
sink.
Installation
1. Insert the temperature sensitive resistor into the
hole in the heat sink.
2. Cover the resistor with a glob of thermally
conductive epoxy.
3. Route the harness as shown and afx it with tape.
4. Continue to install in the reverse order of
removal.
Figure 72: Temperature sensor installed
To Next Page
Loading...
