Service Manual 47
Frame
Charge Port Cover
Tools Required
• Flathead screwdriver
• CA glue
Removal
Make sure the One S1 is powered off and the
charger is not connected.
1. Access the charge port:
a. Disassemble the One S1 (page28).
b. Remove the control board (page38).
c. Remove the rear frame (page42).
2. Use a athead screwdriver to pry the end of the
charge port cover off the mounting studs.
See Figure 68.
CAUTION!
Be careful not to damage the mounting studs.
3. Remove the charge port cover.
Installation
1. Insert the long end of the charge port cover
through the hole in the rear frame.
2. Press the end of the charge port cover onto the
two mounting studs (Figure 68).
3. Apply a drop of CA glue over each mounting
stud to afx the charge port cover in place.
4. Continue to install in the reverse order of
removal.
Mounting studs
Figure 68: Charge port cover attached to mounting studs
Figure 69: Charge port cover, exterior
To Next Page
Loading...
