Segway NINEBOT ONE S1 - Page 31

Service Manual 31
Body
Remove the Frame
1. Using a Phillips screwdriver, remove the four
screws around the exterior edge of the side
panel (Figure 26).
NOTE
One or more of these screws may be underneath
a Warranty Void sticker. Simply press the
screwdriver through the sticker break the seal
and access the screw.
2. Carefully separate the frame from the side panel.
CAUTION!
Do not strain the wires. If you dislodge a wire
from an internal component, you may have to
replace that component.
3. Unplug both LED strips (Figure 27) and carefully
guide the battery wires through the hole.
Separate the Wheel and Side Panel
1. Using a 3 mm hex wrench, remove the four hex
bolts (Figure 28). These connect the side panel
to the wheel.
2. Carefully separate the side panel from the wheel.
CAUTION!
Do not strain the wires. If you damage the motor
harness, you may have to replace the wheel.
Remove screws
Figure 26: Remove the four screws
Figure 27: Unplug the LED strips
Unplug
Guide through hole
Unplug
Figure 28: Remove hex bolts
Remove bolts