Body
30
One S1
Disconnect the Motor Wires
1. Remove the two upper wire guides (Figure 23).
2. Unplug the white connector and three barrel
connectors (Figure 24).
3. Gently but rmly pull up on the wiring harness
to dislodge the third wire guide and the silicone
sealant around it (Figure 25).
4. Pull the wire guide off the harness and gently
scrape any sealant residue off the harness.
Remove wire guides
Figure 23: Remove the two wire guides
Figure 24: Unplug the motor wires
Unplug
Unplug
Remove wire guide
and silicone sealant
Figure 25: Remove wire guide and silicone sealant
To Next Page
Loading...
