Segway NINEBOT ONE S1 - Page 29

Service Manual 29
Body
Remove the Left Side Panel
1. Using a 3 mm hex wrench, remove the four hex
bolts (Figure 19). These connect the side panel
to the wheel.
2. Using a Phillips screwdriver, remove the ve
screws around the exterior edge of the side
panel (Figure 19).
3. Flip the unit over and remove the bottom-right
fastener (Figure 20). Then ip the unit back over.
NOTE
One or more of these screws may be underneath
a Warranty Void sticker. Simply press the
screwdriver through the sticker to break the seal
and access the screw.
4. Carefully lift the side panel from the bottom.
See Figure 21.
CAUTION!
Do not strain the wires. If you dislodge a wire
from an internal component, you may have to
replace that component.
5. Unplug both LED strips (Figure 22) and carefully
guide the battery wires through the hole.
Figure 19: Remove the fasteners
Figure 20: Install the last fastener on the right side panel
Remove one screw
on right side panel
Unplug
Unplug
Guide through
Remove screws
and hex bolts
Figure 21: Lift the side panel from the bottom
Lift up
Figure 22: Unplug LED strips