Service Manual 33
Body
Install the Frame
1. Orient the frame so the motor harnesses are on
the right side (same side as right side panel).
2. Thread the motor harnesses and battery
harnesses through the hole in the side panel.
See Figure 32.
3. Connect both LED strips.
4. Gently lay the frame against the side panel,
making sure not to pinch any wires between the
components.
5. Using a Phillips screwdriver, install four screws
securing the frame to the side panel (Figure 33).
NOTE
There is a hole for one additional screw. You will
install this screw after installing the other side
panel.
6. Connect the motor communication harness
(white connector) and connect the three motor
wires (Figure 34).
7. Route the motor harnesses through the two small
wire guides (MK2a) and press the wire guides
into place.
Wire guides
Plug in
Plug in
Pass through
Figure 32: Plug in both LED strips
Figure 33: Install four screws
Install screws
Figure 34: Connect motor harnesses and install wire guides
To Next Page
Loading...
