Body
34
One S1
Install Left Side Panel
1. Verify that that wire guide (MK2b) is installed.
See Figure 35.
2. Guide the battery harnesses through the hole in
the side panel (Figure 36).
3. Connect both LED strips.
4. Gently lay the side panel against the frame,
making sure not to pinch any wires between the
components.
5. Using a 3 mm hex wrench, install four fasteners
securing the side panel to the wheel (Figure 37).
6. Using a Phillips screwdriver, install ve fasteners
securing the side panel to the frame (Figure 37).
7. Flip the unit over and install the last Phillips-head
fastener on that side (Figure 38).
8. Install a new Warranty Void sticker over the
bottom-right fastener on each side.
Figure 35: Mount the left side panel
Install screw
on right side
Wire guide “MK2b”
Figure 36: Connect the left side panel to the frame
Plug in
Plug in
Guide through hole
Figure 37: Connect the left side panel to the frame
Figure 38: Install the last fastener on the right side panel
Install screws
and hex bolts
To Next Page
Loading...
