Service Manual 39
Frame
Installation
1. Plug in the charge port, buzzer, handle sensor,
and ON/OFF button (Figure 41 and Figure 42).
2. Install the U-grommets as shown in Figure 40.
3. Install the control board assembly:
a. Insert the motor wires through the holes in
the sides of the upper frame.
b. Press the U-grommets into the grooves in the
upper frame (Figure 43).
c. Use a 3 mm hex wrench to install the four
fasteners (Figure 39).
4. Continue to install in the reverse order of
removal.
Figure 42: Plug in all wire harnesses
LED Strips, Front
LED Strips, Rear
Battery PowerBattery Communication
Battery Communication Battery Power
Motor Communication
Motor Power
LEFT SIDE
RIGHT SIDE
Figure 44: Control board connectors
Figure 43: Install U-grommets
To Next Page
Loading...
