Segway NINEBOT ONE S1 - Page 41

Service Manual 41
Frame
Thermal
Paste
Thermal
Paste
Figure 49: Apply thermal paste
FRONTREAR
Plug In
Figure 50: Plug in the temperature sensor
Figure 51: Rubber gasket orientation
Figure 52: Control board orientation
FRONT
REAR
Lip
Assembly
1. Apply thermal paste on the the two aluminum
pads, as shown in Figure 49.
2. Place the control board on top of the heat sink
and install nine screws:
a. Five screws on top (Figure 46).
b. Four screwson bottom (Figure 47).
3. Plug in the temperature sensor (Figure 50).
4. Orient the control board gasket as shown in
Figure 51, with the lip up and toward the rear.
Install the control board gasket.
5. Continue to install in the reverse order of
removal.
NOTE
If you installed a new control board, you will need
to reset the serial number (page64).