Segway SGW500F-A7 - Front;Rear Axle Gear Oil

103
MAINTENANCE,STORAGE AND TRANSPORTATION
FRONT/REAR AXLE GEAR OIL
The filling plugs of the front and rear axle are located on the
left side of the axle body, and the drain plugs are located at the
bottom of the axle body.
1
2
1
2
3
2
2
3
1
Filling plug
2
O-ring
3
Drain plug
1. Position the vehicle on a level surface. Remove filling plug.
2. Remove the oil drain plug and O-ring, so that the grease in the
axle body is completely discharged.
3. Clean and reinstall the exhaust plug and O-ring. If the O-ring is
aging, replace it with a new O-ring.
4. Reinstall the drain plug and O-ring according to the
recommended torque.
5. Add the appropriate amount of recommended oil, the level
should reach the bottom of the filling hole thread.
6. Reinstall the filling plug and O-ring according to the
recommended torque.
7. Check for leaks and properly dispose of used liquids.
Torque Drain Plug: 11.8-14.8ft·lb. (16~20N.m )
NOTICE
Dispose of used fluid properly.