EasyManuals Logo

Segway SGW500F-A7 User Manual

Segway SGW500F-A7
179 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #146 background imageLoading...
Page #146 background image
136
MAINTENANCE,STORAGE AND TRANSPORTATION
BATTERY INSTALLATION
NOTICE
To reduce the chance of sparks: Whenever the battery is removed,
disconnect the black (negative) cable first.When reinstalling the
battery. finally install the black (negative) cable.
1. Clean battery cables and terminals with a hard wire brush.
Corrosion can be removed with a solution of 1 cup water and 1
tablespoon baking soda.Rinse well and dry thoroughly.
2. Put the battery in the tray.
3. Connect and tighten the red (positive) cable.
4. Connect and tighten the black (negative) cable.
5. Install a clear battery vent from the vehicle to the battery
vent.(For conventional batteries only).
6. Install the battery press plate.
7. Tighten the battery clamp bolt.
8. Verify that cables are properly wired.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Segway SGW500F-A7 and is the answer not in the manual?

Segway SGW500F-A7 Specifications

General IconGeneral
BrandSegway
ModelSGW500F-A7
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals