106
MAINTENANCE,STORAGE AND TRANSPORTATION
CVT DRYING
In some cases, water may inadvertently soak into the CVT system,
so let it dry before driving.
1. Remove the clutch drain plug.
2. After the water drains out, reinstall the water drain plug.
3. Put the transmission in "P" and pull up the parking handle.
4. Start the engine.
5. Use different throttles for 10-15 seconds to drain moisture
and air, dry the belt and CVT. Do not leave the throttle on full
throttle for more than 10 seconds.
6. Allow the engine speed to remain at idle speed. Use the
brakes. Shift the transmission to the lowest available range.
7. Belt slip test, if the belt slips, repeat the process.
8. If your vehicle needs service, Segway dealers can help.
To Next Page
Loading...
