Sekonic LITEMASTER PRO - Page 8

8
b)Remove the two screws that hold the JR11-902(JR21-902)PCB/2 Assembly.
* The screw tightening torque is to be 7~9c*N*m(6.9~8.8kg*cm)
c)To prevent damage to the connector, remove it by lifting it straight up so that the JR11-901(JR21-901)
PCB/1 Assembly.
Cautions during assembly
* The screw tightening torque is to be 7~9c*N*m(6.9~8.8kg*cm)
* When screwing the JR11-902(JR21-902)PCB/2 Assembly make sure not to bite the wiring.
(JR109007 Wire Harness / F, JR109009 Wire Harness /H, JR109010 Wire Harness /J)
Between the PCB Assembly are connected
by the connector.
Careful not to damage during removal.
Be removed just abov
e
the substrate.
JR11-901(JR21-901)
PCB/1 Assembly.
A
bunch of white wire soldered to
the upper round.
JR109010
Wire Harness /J
Twist along the leading edge o
f
the line bundle A and bundle lin
e
B, soldered to the round on th
e
left.
JR11-902
(JR21-902)
PCB/2
ZA348(M1.7×6)
(two screws )
JR11-902
(JR21-902)
PCB/2 Assembly