7
c) Detach of the lead wire soldered to the round of JR11-902（JR21-902） PCB (2) Assembly using the
soldering iron.
Cautions during assembly
* Soldered to the PCB (2) Assembly to JC109016( Wire Harness / N) (See photo above)
* When screwed the Main Frame Cover / R Assy(JR10-122) , make sure that there is no deformation
of the wire bundle and biting.
* ZA348(M1.7*6) The screw tightening torque is to be 10~14c*N*m(9.8~13.7kg*cm)
*
3.1.2 Removal of JR11-902(JR21-902) PCB /2 Assembly
a) Detach all of the lead wires soldered to the round of JR11-902 PCB/2 Assembly using the soldering
iron. Refer to the diagram below for the wiring. (JR109007 Wire Harness / F, JR109009 Wire
Harness /H, JR109010 Wire Harness /J)
JR11-902
(JR21-902)
PCB(2)Assembly
JC109016
JR109010 :Wire Harness /J
(two places)
JR109007 : Wire Harness /F
JR109009 : Wire Harness /H
JR11-902
(JR21-902)
PCB(2)Assembly
To Next Page
Loading...
