Select.live Operation Selectronic Australia
OI0009 Revision 01 Select.live User Manual 33
My Network table – shows information and action for the Wi-Fi and
Ethernet of the device.
• Name – Wi-Fi and Ethernet.
• Mode – Mode the of Wi-Fi and Ethernet
o AP – Ad-hoc (Hotspot) mode, only for Wi-Fi
o Client – Normal mode for Wi-Fi and Ethernet
• DHCP – DHCP mode for the Ethernet only (not available for Wi-Fi)
o on – DHCP is enabled for the Ethernet only
o off – DHCP is disabled for the Ethernet only
• IP – IP address of Wi-Fi and Ethernet respectively. If not available,
represented by “- “.
• Netmask – Netmask address of Wi-Fi and Ethernet respectively. If
not available, represented by “- “.
• Action – [Edit] buttons.
o Wi-Fi [Edit] – open a form to edit Wi-Fi connection (See
page 36)
o Ethernet [Edit] – open a form to edit Ethernet connection
(See page 38)
[Apply Network Changes] button – on click, applies changes made in Wi-Fi
and Ethernet connection.
Device firmware status (see page 40)
• Status – provide the status of the firmware by the following text:
o “Firmware is up-to-date”
o “Firmware can be updated to x.x.x”
o “Firmware update x.x.x downloading in progress…”
o “Firmware update x.x.x is downloaded and ready to install.”
o “FIRMWARE UPGRADE IN PROCESS…”
• [Check for new Firmware] button – Changes button label as follows:
o [Check for new Firmware] – on click, check for new
firmware. If available, change the status text to “New
Firmware is available” and the button to [Download
Firmware]
o [Download Firmware] – on click, download new firmware
and changes button to [Cancel Download] during download
and [Install Firmware Update] after download
o [Install Firmware Update] – On click install the firmware and
reboots.
To Next Page
Loading...
